30 TON INDUSTRIAL RENTAL AC UNIT WITH HEAT & DH MODES

INFORMATION

Spec Sheet

FEATURES

  • Hermetic scroll compressor/s
  • Direct drive High Static plenum fan with 15hp TEFC motor
  • Maximum rated static pressure of 6.5 in-wg
  • Estimated air flow range of 1,600 – 6,000 cfm
  • Hydrophilic coated, non-lanced condenser fins
  • Hydrophilic coated evaporator fins
  • Stainless steel hardware
  • Stainless Steel drain pan
  • Permanently installed drain pan P-trap (protected within unit base)
  • Phase monitor and Incorrect phase indicator light (red)
  • Circuit Breakers on all motors
  • Blower VFD with inline starter and bypass switch
  • Unit heat package:
    • 2 Independent stages, 48KW total
    • 32KW stage 1
    • 16KW stage 2
  • Stainless steel sheathed, hermetically sealed, finned tubular heating elements
  • Hot dipped galvanized full tubular rental frame with fork pockets & tie-down points
  • Overhead certified lift frame
  • Entering and leaving air temperature sensors
  • Unit can run in COOLING/HEATING or DH modes
    • Cooling unit may run in HAND (manual) MODE of LOCAL (via PLC control) MODE
    • Unit can control off supply or return air temperature via RS/SA switch
  • In DH mode both stages of cooling and 1 stage heat may operate simultaneously
  • Quiet operation

30 Ton Industrial Rental AC Unit

SPECIFICATIONS

GENERAL 
Duct/Hose Connections (1) 20” Supply / (2) x 20” Return
Blower motor 7.5 hp
Unit Dimensions 97”L x 72”W x 98¼”
Filter Size (6) 16 x 20 x 2
ELECTRICAL
Certification ETL, UL 1995 – CSA 236 STD 22.2
Single Point Power Supply 460V/3PH/60HZ
Connections Single point Series 16 Cam-Lok connections
Cooling only Full Load Amps 54.2 A (460V)
DH Mode Full Load Amps 94.2 A
Unit MCA 114 A
Unit MFS 125 A

 

INDUSTRIAL AIR CONDITIONERS

 


LEARN MORE